20X Airbag SRS RESISTOR AIRBAG WARNING LIGHT DELETE EASIEST TOYOTA HONDA JAPAN

Description

This listing includes:
10pcs NEW condition and high-quality Japanese resistors
5pcs new uncommon resistors plus,
5pcs new hard to find resistor unit.
----A total of
20 units
with FAST AND FREE shipping to all USA, Canada
and
USA territories.
Ships from Richmond Virginia by either USPS first class or Priority mail service depending on quantity ordered.
This 20 resistor kit will cover 90% of the brands and models sold in the USA since 1990.
INSTALLATION OF THE RESISTORS
WILL ONLY CLEAR THE SRS AIRBAG LIGHT IF THE CAR HAS NOT BEEN INVOLVED IN AN ACCIDENT.
In the event that your car has been in an accident most car require the ECU airbag Unit to be reset or cleared from the crash data, this is normally done by removing the ECU unit and have it cleared by a specialist on SRS airbag data crash reset.
If you are Installing
Aftermarket Seats or Steering wheel
this will leave you with the annoying warning light on the dashboard (SRS). To remove (turn off) this annoying warning light, it is possible by fitting a low-value resistor across the terminals. This will create and send a
“Fake airbag connected signal"
to the ECU airbag module and tell the system that the light can be turned off.
Plenty of videos can be found on YouTube that will teach you how to do this, just search for “srs resistor” “airbag resistor” “srs trick bypass”
This listing is for the resistors you are looking for.
It Can be used for Steering wheel airbag and seat, pretensioners, side curtains, buckles, seats, knee airbag and all other airbags location.
DISCLAIMER:
Check your local laws regarding the driving of a car without airbag unit, altered airbag/restraint system.
We are not responsible for any ticket or accident concerning the use of this item. Use at your own risk.
20 resistors included per auction
.
10x most common resistance found in Japanese, Asian brands
5 & 5 extra units with different resistance value for the unconventional airbags.
Fast
Free shipping
In the pictures, scanner shows SRS fault in a
2010 Toyota Prius
. You may notice that there was a code before I connected the resistor to it. Then cleared the code with the scanner and with the resistor in place… the code and the warning light is gone!!!
Before carrying out any alterations to SRS restraint system inside of your vehicle, you should be aware of the safety risks involved. Removal of airbags sometimes is a risk.
ALWAYS ALWAYS DISCONNECT THE 12V BATTERY BEFORE ATTEMPT OF ANY AIRBAG JOB.
The sale of these resistors is strictly WITH the understanding that you personally accept and comprehend the risks involved.
Ø
Resistors are only suitable for a WORKING SRS/AIRBAG SYSTEM, it will NOT work on a system that has logged a CRASH DATA.
Ø
Installation will not always remove the light, you may have to reset the system OR sometimes by disconnecting the car battery this can be achieved.
Ø
Follow the manufacturer's procedures
Ø
Airbag systems can be dangerous if working with car battery connected
Ø
We sell this kit with no guarantee and accept no responsibility for damage to you or your car
Ø
BUYER MUST SHIP BACK AND PAY SHIPPING CHARGES IN ORDER TO RECEIVE A REFUND!!
*********REMINDER: ALWAYS DISCONNECT THE 12V BATTERY BEFORE ATTEMPT OF ANY AIRBAG JOB**********